#Jenga game rules with 4 dice how to
#Jenga game rules with 4 dice install

We chose to use 16 ½ inches because the original measurements are 14 inches plus an inch of additional space on the inside and an additional 1 ½ inches for the two side pieces’ width. Start by ripping down your piece of plywood until it’s 16 ½ inches wide for the top and bottom pieces. Step 3 – Cut Out Your Carrying Case Pieces You can flip this case over to double it as a flat surface to play on out in the yard too. It also gives you space to slip your fingers into the holes to carry it. Consider adding an inch to the width and height and 1 ½ inches to the length to give yourself a little wiggle room. The measurements should be 14 inches deep, 21 inches wide, and 10 ½ inches tall. Then, you stack them upwards until you run out of blocks. We chose to do a stack with six pieces side by side and two pieces behind that on the end. You can stack the newly cut pieces however you like to measure for the case. Step 2 – Stack the Pieces to Measure to Create the Case Put a small block of wood along the line and clamp it securely in place. Measure from the end of the cut and mark the board at 10.5-inches. Clamp a piece of scrap wood to your chop saw and cut part ways through it. A great way to make these cuts very quickly is to make a jig. You’ll make several pieces out of each 2×4. Tight, small knots are something you can get away with, but you’ll want the pieces to be so smooth that they glide against one another without having to sand them. This is far from traditional finish lumber, or you can look for premium-quality 2x4s that come with fewer knots. You may want to pay a little more for construction-grade stud lumber. Pick out the 2x4s that have as few knots in the wood as possible.

Finish for outside of box (lacquer or polyurethane).

Door hardware including a door clasp and small hinges.

6 – 8 foot 2×4’s and 1/2 inch or 3/4 inch plywood for your case.

After you stack all of the blocks following this pattern, you’ll get a tower that is 18 layers tall.

You follow this by another layer of three that you turn 90° and put on top of the previous row. Traditionally, any jenga game you get has 54 pieces, and one block needs to be as long as the width of three blocks laid side by side.

#Jenga game rules with 4 dice how to

How to Create a Traditional Yard Jenga Set – Step by Step

How to Create a Yard Jenga Set with a Twist.

Step 6: Sand and Apply Boiled Linseed Oil to the Blocks.

#Jenga game rules with 4 dice install

Step 5: Assemble Your Box, Apply the Finish, and Install the Hardware.Step 4 – Plan Out and Cut the Handles for the Case.Step 3 – Cut Out Your Carrying Case Pieces.Step 2 – Stack the Pieces to Measure to Create the Case.How to Create a Traditional Yard Jenga Set – Step by Step.